Re: E-stop Problem + more
Posted by
imranjawaid@e...
on 2000-06-10 06:48:13 UTC
--- In CAD_CAM_EDM_DRO@egroups.com, Ray Henry <rehenry@u...> wrote:
that is for STG card :-(.
http://www.isd.mel.nist.gov/projects/emc/stg.html ( pin assignments)
donno wht is it for at Nist site
ftp://ftp.isd.mel.nist.gov/pub/emc/emcsoft/extstgmot.c
Imran
> >Message: 16electronics
> > Date: Fri, 09 Jun 2000 05:05:36 -0000
> > From: imranjawaid@e...
> >Subject: Re: E-stop Problem + more
> >
> <snip>
> >
> >I tried to short pin 13 with 19 (GND) on my only parallel port ,
> >changed the ini file aux_io port to 378 . but no luck.
> >
> >I tried Ray procedure (which is to change EMCIO to minimillio in
> >emc.ini)& got out of Estop only in steppermod.o file.
> >But i'm using the stg2mod.o file (STG 2 card). /w AC Servo. The
> >minimillio file didn't workout for the STG2 card.
> >
> >I prefer the ini file editing prcedure as i'm not good in
> >or Linux.the stg
>
> I'm not very well versed here but I think that once you switch to
> definitions in the ini file then you have to use the stg pins to dothe
> work. I know that I've seen a document that lists all of the pinson the
> stg and what signal they hold for emc but I don't know where it is.Here are the STG pin assignments. But i can't figure out the the bit
>
> Ray
that is for STG card :-(.
http://www.isd.mel.nist.gov/projects/emc/stg.html ( pin assignments)
donno wht is it for at Nist site
ftp://ftp.isd.mel.nist.gov/pub/emc/emcsoft/extstgmot.c
Imran
Discussion Thread
imranjawaid@e...
2000-06-04 22:35:44 UTC
E-stop Problem + more
Tim Goldstein
2000-06-05 06:43:41 UTC
RE: [CAD_CAM_EDM_DRO] E-stop Problem + more
Jon Elson
2000-06-05 12:44:00 UTC
Re: [CAD_CAM_EDM_DRO] E-stop Problem + more
Ray Henry
2000-06-06 09:46:47 UTC
Re: Re: E-stop Problem + more
byron@w...
2000-06-06 18:01:10 UTC
Re: [CAD_CAM_EDM_DRO] E-stop Problem + more
imranjawaid@e...
2000-06-08 22:05:40 UTC
Re: E-stop Problem + more
Ray Henry
2000-06-09 10:27:36 UTC
Re: Re: E-stop Problem + more
imranjawaid@e...
2000-06-10 06:48:13 UTC
Re: E-stop Problem + more
Ray Henry
2000-06-13 15:57:38 UTC
Re: Re: E-stop Problem + more