CAD CAM EDM DRO - Yahoo Group Archive

Re: Smallish CNC Miller

Posted by Polaraligned
on 2005-04-29 09:47:50 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, R Rogers <rogersmach@y...> wrote:
> Go with servos. I have a set of the Rockford rolled ballscrews and
they are very nice conversion kit. Everything that is needed is
included. Take about two hours to install. The tolerance is .003" per
foot. And that is a tolerance not a guarantee they will be out that
much. Even if they are its only .00025" per inch of error.
>
> Ron


Hi Ron,
I printed the PDF data sheet for Rockford "Bridgeport" conversion
screws. The ball nut is a larger diameter than that of my
yoke and the mounting flange appears to have no way to mount onto
the yoke. Did you have to make any modifications to use these screws?
or maybe their spec sheet is wrong.

Scott

Discussion Thread

xj5373 2005-04-28 13:47:52 UTC Smallish CNC Miller R Rogers 2005-04-28 16:28:28 UTC Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller turbulatordude 2005-04-28 16:38:45 UTC Re: Smallish CNC Miller Blue 2005-04-28 16:46:59 UTC Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller Polaraligned 2005-04-29 09:47:50 UTC Re: Smallish CNC Miller Polaraligned 2005-04-29 10:03:25 UTC Re: Smallish CNC Miller R Rogers 2005-04-29 11:47:20 UTC Re: [CAD_CAM_EDM_DRO] Re: Smallish CNC Miller Ian Haynes 2005-04-30 14:13:09 UTC Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller R Rogers 2005-04-30 17:10:01 UTC Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller Blue 2005-04-30 18:45:49 UTC Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller Alex Holden 2005-05-01 02:10:07 UTC Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller Blue 2005-05-02 15:03:11 UTC Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller Alex Holden 2005-05-03 00:32:18 UTC Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller Blue 2005-05-03 17:38:26 UTC Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller cnc_4_me 2005-05-04 00:56:10 UTC Re: Smallish CNC Miller Blue 2005-05-05 17:43:17 UTC Re: [CAD_CAM_EDM_DRO] Re: Smallish CNC Miller cnc_4_me 2005-05-05 19:05:11 UTC Re: Smallish CNC Miller Blue 2005-05-06 17:07:14 UTC Re: [CAD_CAM_EDM_DRO] Re: Smallish CNC Miller