Re: Smallish CNC Miller
Posted by
cnc_4_me
on 2005-05-04 00:56:10 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Blue" <jo001k1132@b...> wrote:
not run the windings in parallel for 55volt double current operation.
In its current configuration each end of a coil is connected to the
other in a series additive configuration.
Wally
> Hi,centre tap
>
> I'm not sure yet if it is possible to combine both sides of the
> or should I use it as two supplies or 55 volts?If it is a true 55 0 55 transformer with 3 wires only. Then you can
>
> Regards,
>
> Terry
>
> > > No I'm not mistaken. These transformers are centre-tapped 55-0-55.
> >
> > You're right, I'd forgotten they were centre tapped.
not run the windings in parallel for 55volt double current operation.
In its current configuration each end of a coil is connected to the
other in a series additive configuration.
Wally
Discussion Thread
xj5373
2005-04-28 13:47:52 UTC
Smallish CNC Miller
R Rogers
2005-04-28 16:28:28 UTC
Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller
turbulatordude
2005-04-28 16:38:45 UTC
Re: Smallish CNC Miller
Blue
2005-04-28 16:46:59 UTC
Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller
Polaraligned
2005-04-29 09:47:50 UTC
Re: Smallish CNC Miller
Polaraligned
2005-04-29 10:03:25 UTC
Re: Smallish CNC Miller
R Rogers
2005-04-29 11:47:20 UTC
Re: [CAD_CAM_EDM_DRO] Re: Smallish CNC Miller
Ian Haynes
2005-04-30 14:13:09 UTC
Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller
R Rogers
2005-04-30 17:10:01 UTC
Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller
Blue
2005-04-30 18:45:49 UTC
Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller
Alex Holden
2005-05-01 02:10:07 UTC
Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller
Blue
2005-05-02 15:03:11 UTC
Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller
Alex Holden
2005-05-03 00:32:18 UTC
Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller
Blue
2005-05-03 17:38:26 UTC
Re: [CAD_CAM_EDM_DRO] Smallish CNC Miller
cnc_4_me
2005-05-04 00:56:10 UTC
Re: Smallish CNC Miller
Blue
2005-05-05 17:43:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: Smallish CNC Miller
cnc_4_me
2005-05-05 19:05:11 UTC
Re: Smallish CNC Miller
Blue
2005-05-06 17:07:14 UTC
Re: [CAD_CAM_EDM_DRO] Re: Smallish CNC Miller