Re: [CAD_CAM_EDM_DRO] tapper attachment for southbend

Stan: I have a South Bend with the taper attachment. The cross-slide is
a special piece for taper attachments only. It extends 9 inches beyond
the back of the carriage and is one piece.This is where you establish
the basic diameter of the piece you are machining. The cross-slide feed
screw must be dissabled(disconnect the nut ) leaving the compound to
adjust your cut. You are looking at quite a project!

smcdonal wrote:

> Does anyone here have the plans on makeing a tapper attachment for a
> 9"
> southbend lathe. I know what they look like but i need the basic
> dimensions for the cross slide and the guide rail that controls the
> tapper. Thanks
> Stan
>
> -----------------------------------------------------------------------
>
> -----------------------------------------------------------------------
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager

[Non-text portions of this message have been removed]