CAD CAM EDM DRO - Yahoo Group Archive

Re: Reducing diameter of a ball screw shaft.

on 2005-05-18 07:18:19 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Blue" <jo001k1132@b...> wrote:
> Hi,
>
> You can machine the ends in one of two ways, use a tool-post grinder
or if
> the metal is soft enough use TCT tooling.
>
> Regards,
>
> Terry


You can also weld an extension on the end and machine that.

Or, make a sleeve and put that on.


The screws I have are hard and carbide tooling in the lathe took a
beating before I gave up. carbide does not like interupted cuts such
as the threads.

Next time it will be an hour at the post grinder to get down to the
minor diameter or weld extentions.


Dave

Discussion Thread

robertokx 2005-05-18 03:03:02 UTC Reducing diameter of a ball screw shaft. Blue 2005-05-18 06:23:10 UTC Re: [CAD_CAM_EDM_DRO] Reducing diameter of a ball screw shaft. turbulatordude 2005-05-18 07:18:19 UTC Re: Reducing diameter of a ball screw shaft. Blue 2005-05-18 07:48:31 UTC Re: [CAD_CAM_EDM_DRO] Re: Reducing diameter of a ball screw shaft. JanRwl@A... 2005-05-18 21:42:14 UTC Reducing diameter of a ball screw shaft. ducatirod 2005-05-19 07:34:09 UTC Re: Reducing diameter of a ball screw shaft. Mike Delany 2005-05-19 07:37:57 UTC Re: [CAD_CAM_EDM_DRO] Reducing diameter of a ball screw shaft. Jon Elson 2005-05-19 08:12:13 UTC Re: [CAD_CAM_EDM_DRO] Reducing diameter of a ball screw shaft. George Taylor, IV 2005-05-19 21:35:40 UTC RE: [CAD_CAM_EDM_DRO] Reducing diameter of a ball screw shaft. Jon Elson 2005-05-19 22:18:23 UTC Re: [CAD_CAM_EDM_DRO] Reducing diameter of a ball screw shaft. turbulatordude 2005-05-19 22:33:51 UTC Re: Reducing diameter of a ball screw shaft. Jon Elson 2005-05-20 09:54:40 UTC Re: [CAD_CAM_EDM_DRO] Re: Reducing diameter of a ball screw shaft.