Re: [CAD_CAM_EDM_DRO] Re: Model Engineers Workshop volume103
Posted by
Marcus and Eva
on 2005-06-07 19:47:34 UTC
Hi Mike:
I sure hope you're not planning to drive the ballscrew through an
extension shaft that's been glued in place.
That's a terrible idea...you'll never know when the darned thing will bust
loose and destroy things.
I realize that it may SEEM easier to do it this way, but I really doubt it.
Turning a ballscrew end is not that big a deal...you just need patience and
commonsense.
By far the hardest part is dialling it in accurately enough...making an
extension shaft doesn't relieve you of this requirement.
If by chance, you overshoot and turn the shaft end too small, it's a far
better option to simply sleeve the undersize journal than to add an
extension.
I realize that the MEW author claims his method to have been successful, but
I still don't like it...it's inherently weak and no less effort to do
accurately.
Cheers
Marcus
I sure hope you're not planning to drive the ballscrew through an
extension shaft that's been glued in place.
That's a terrible idea...you'll never know when the darned thing will bust
loose and destroy things.
I realize that it may SEEM easier to do it this way, but I really doubt it.
Turning a ballscrew end is not that big a deal...you just need patience and
commonsense.
By far the hardest part is dialling it in accurately enough...making an
extension shaft doesn't relieve you of this requirement.
If by chance, you overshoot and turn the shaft end too small, it's a far
better option to simply sleeve the undersize journal than to add an
extension.
I realize that the MEW author claims his method to have been successful, but
I still don't like it...it's inherently weak and no less effort to do
accurately.
Cheers
Marcus
Discussion Thread
mmeyers1111
2005-06-06 20:08:26 UTC
Model Engineers Workshop volume103
Paul Kelly
2005-06-06 20:18:39 UTC
RE: [CAD_CAM_EDM_DRO] Model Engineers Workshop volume103
mmeyers1111
2005-06-07 08:12:10 UTC
Re: Model Engineers Workshop volume103
George Taylor, IV
2005-06-07 13:08:01 UTC
Re: [CAD_CAM_EDM_DRO] Re: Model Engineers Workshop volume103
mmeyers1111
2005-06-07 16:48:40 UTC
Not available - Model Engineers Workshop volume103
Marcus and Eva
2005-06-07 19:47:34 UTC
Re: [CAD_CAM_EDM_DRO] Re: Model Engineers Workshop volume103
Hugh Prescott
2005-06-07 20:12:41 UTC
Re: [CAD_CAM_EDM_DRO] Re: Model Engineers Workshop volume103