Re: DC Speed controller
Posted by
campgems
on 2005-06-25 18:44:46 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Blue" <jo001k1132@b...>
wrote:
you send it to me off-list? I don't want to spend too much of the
hard earned on this as it is only going to be used to drive my
milling table until I get some Gecko's running.
tread Mill motors. If I remember correctly, my controller was abou
$30.00 New. You couldn't build one for that.
Actually, I just checked and they are $60.00, still a bargain.
http://www.surpluscenter.com/item.asp?UID=2005062520291586&item=11-
2269&catname=electric
Use the whole link
Don
wrote:
> Hi,perminant magnet DC motor of 2hp running at 110 volts? If so could
>
> Does anyone have a circuit diagram for a PWM speed control for a
you send it to me off-list? I don't want to spend too much of the
hard earned on this as it is only going to be used to drive my
milling table until I get some Gecko's running.
>I would check out a couple of the surplus supply houses that sell
>
tread Mill motors. If I remember correctly, my controller was abou
$30.00 New. You couldn't build one for that.
Actually, I just checked and they are $60.00, still a bargain.
http://www.surpluscenter.com/item.asp?UID=2005062520291586&item=11-
2269&catname=electric
Use the whole link
Don
Discussion Thread
Blue
2005-06-25 18:20:18 UTC
DC Speed controller
campgems
2005-06-25 18:44:46 UTC
Re: DC Speed controller
Andrey Lipavsky
2005-06-25 19:06:21 UTC
RE: [CAD_CAM_EDM_DRO] DC Speed controller
turbulatordude
2005-06-25 23:27:39 UTC
Re: DC Speed controller
Blue
2005-06-26 17:52:46 UTC
Re: [CAD_CAM_EDM_DRO] DC Speed controller
victorlorenzo
2005-06-26 18:43:47 UTC
Re: DC Speed controller
wanliker@a...
2005-06-26 19:28:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: DC Speed controller
Blue
2005-06-27 11:05:51 UTC
Re: [CAD_CAM_EDM_DRO] DC Speed controller
Wayne Weedon
2005-06-27 11:43:25 UTC
Re: [CAD_CAM_EDM_DRO] DC Speed controller
Nader Atifeh
2005-06-29 19:55:56 UTC
Re: DC Speed controller-OT