Re: [CAD_CAM_EDM_DRO] weird motor problem on my cnc mill
Posted by
Ed Fanta
on 2005-07-09 12:00:11 UTC
skykotech wrote:
problem follows the encoder or the Gecko. Also check if the Gecko is
getting warm, mine was acting up until I put a fan on the heatsink. Ed.
>Check your encoder, swap it with another axis if possible to see if the
> I am experiencing a strange problem on my x axis motor on my cnc
> mill. The motor is a Fanuc 0, 56V DC brush, 4 pole. One direction
> the motor runs smooth, the other direction it growls and shudders.
> I took out each of the four brushes and they look perfect. Peering
> at the commutators, they look perfect too. The bearings *feel* ok
> when you turn the shaft of the motor either direction by hand. I
> ran the motor off of a 1 volt supply and it spins in both directions
> without stalling.
problem follows the encoder or the Gecko. Also check if the Gecko is
getting warm, mine was acting up until I put a fan on the heatsink. Ed.
Discussion Thread
skykotech
2005-07-09 10:11:10 UTC
weird motor problem on my cnc mill
Ed Fanta
2005-07-09 12:00:11 UTC
Re: [CAD_CAM_EDM_DRO] weird motor problem on my cnc mill
Bob Muse
2005-07-09 15:11:10 UTC
Re: [CAD_CAM_EDM_DRO] weird motor problem on my cnc mill
skykotech
2005-07-09 20:45:44 UTC
Re: weird motor problem on my cnc mill
R Rogers
2005-07-09 21:17:41 UTC
Re: [CAD_CAM_EDM_DRO] Re: weird motor problem on my cnc mill
skykotech
2005-07-09 22:48:27 UTC
Re: weird motor problem on my cnc mill