CAD CAM EDM DRO - Yahoo Group Archive

Re: weird motor problem on my cnc mill

Posted by skykotech
on 2005-07-09 22:48:27 UTC
>Are the brushes at right angles to the armature? In other words are
>they angular to the shaft. If so, the motor was intended to only be
>ran in one direction. Many DC motors are that way.

It is the original Fanuc model 0 servo motor that was on the Shizuoka
cnc mill, so I am sure it is meant to run both directions :-)

(I did notice the brushes are indeed at right angles to the armature
when I inspected each of the 4 of them)

Turning the armature.....dang, I would want to obtain a spare Fanuc 0
motor before I did *that*..... :-/

Thanks for the tips,

Rick

Discussion Thread

skykotech 2005-07-09 10:11:10 UTC weird motor problem on my cnc mill Ed Fanta 2005-07-09 12:00:11 UTC Re: [CAD_CAM_EDM_DRO] weird motor problem on my cnc mill Bob Muse 2005-07-09 15:11:10 UTC Re: [CAD_CAM_EDM_DRO] weird motor problem on my cnc mill skykotech 2005-07-09 20:45:44 UTC Re: weird motor problem on my cnc mill R Rogers 2005-07-09 21:17:41 UTC Re: [CAD_CAM_EDM_DRO] Re: weird motor problem on my cnc mill skykotech 2005-07-09 22:48:27 UTC Re: weird motor problem on my cnc mill