CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Advise on motor selection for use with G320’s

Posted by Les Newell
on 2005-07-13 14:33:20 UTC
These motors are nice but overkill for a plasma unless you intend to use
it for routing as well.

Les

R Rogers wrote:

>Steve, Talk to Dan Mauch/Camtronics. He can get you brand new 14 lb-in DC brush servos with your choice of encoder for $249 each. They are Nema 34 and are very powerful for their size. Stall torque over 50 lb-in. 90 volt and 3800 RPM. Good Servo for Geckodrives G320.
>
>Ron
>
>

Discussion Thread

Steve 2005-07-13 07:27:23 UTC Advise on motor selection for use with G320’s R Rogers 2005-07-13 08:06:11 UTC Re: [CAD_CAM_EDM_DRO] Advise on motor selection for use with G320’s Les Newell 2005-07-13 14:33:20 UTC Re: [CAD_CAM_EDM_DRO] Advise on motor selection for use with G320’s Les Newell 2005-07-13 14:40:40 UTC Re: [CAD_CAM_EDM_DRO] Advise on motor selection for use with G320’s thecalfees 2005-07-13 23:28:57 UTC Re: Advise on motor selection for use with G320’s