Re: [CAD_CAM_EDM_DRO] How do I make????

on 2000-06-19 21:00:33 UTC

In a message dated 6/19/00 9:45:12 PM Mountain Daylight Time, JanRwl@...
writes:

<< Have you
PRICED any? WOW! >>
I have priced them, that is why I wanted more information. WOW is an
understatement, almost floored me when I was quoted over $40.00 for one for a
1/4 shaft. I did not order any.
bill

Discussion Thread

JanRwl@A... 2000-06-19 20:44:05 UTC Re: [CAD_CAM_EDM_DRO] How do I make???? wanliker@a... 2000-06-19 21:00:33 UTC Re: [CAD_CAM_EDM_DRO] How do I make???? wbhinkle@a... 2000-06-19 21:25:03 UTC Re: [CAD_CAM_EDM_DRO] How do I make???? andrew abken 2000-06-19 21:48:56 UTC Re: [CAD_CAM_EDM_DRO] How do I make???? Jon Elson 2000-06-19 22:03:32 UTC Re: [CAD_CAM_EDM_DRO] How do I make???? Jon Elson 2000-06-19 22:06:22 UTC Re: [CAD_CAM_EDM_DRO] How do I make???? wanliker@a... 2000-06-20 08:12:38 UTC Re: [CAD_CAM_EDM_DRO] How do I make????