CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Manual to CNC Lathe Conversion

Posted by art
on 2005-08-13 09:09:40 UTC
Hi:

>>As I understand in, Mach(x) syncs up to the spindle once for each
pass, and assumes the spindle speed won't change when the cut
begins. If you need precision threads, that may not be good enough.

Actually, MachX uses the feedback pnce per Rev, and adjusts the speed of
the Z if required. It can adjust several times per rotation, but it was
found that once per rotation is all thats required.

Thanks,
Art
www.artofcnc.ca
----- Original Message -----
From: "Jon Elson" <elson@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Saturday, August 13, 2005 1:00 AM
Subject: Re: [CAD_CAM_EDM_DRO] Manual to CNC Lathe Conversion


> pondindustrial wrote:
>

Discussion Thread

pondindustrial 2005-08-12 19:27:23 UTC Manual to CNC Lathe Conversion turbulatordude 2005-08-12 20:06:40 UTC Re: Manual to CNC Lathe Conversion pondindustrial 2005-08-12 20:17:31 UTC Re: Manual to CNC Lathe Conversion Jon Elson 2005-08-12 21:01:43 UTC Re: [CAD_CAM_EDM_DRO] Manual to CNC Lathe Conversion pondindustrial 2005-08-12 21:26:30 UTC Re: Manual to CNC Lathe Conversion art 2005-08-13 09:09:40 UTC Re: [CAD_CAM_EDM_DRO] Manual to CNC Lathe Conversion art 2005-08-13 09:13:58 UTC Re: [CAD_CAM_EDM_DRO] Re: Manual to CNC Lathe Conversion turbulatordude 2005-08-13 09:43:31 UTC Re: Manual to CNC Lathe Conversion -THREADING art 2005-08-14 10:32:36 UTC Re: [CAD_CAM_EDM_DRO] Re: Manual to CNC Lathe Conversion -THREADING Fred Smith 2005-08-15 08:09:49 UTC Re: Manual to CNC Lathe Conversion -THREADING