Re: proximity sensor
Posted by
alphawolf45
on 2005-08-20 10:45:38 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, R Rogers <rogersmach@y...>
wrote:
versa. Estop circuits can do this on pin 10 if not wired correctly.
on limit switchs with Mach2 and the Campbell breakout board..I think I
finally have it figured out but the damage is now done..I'll end up
using "A" axis terminals for the "Y" until I get this board repaired or
I replace it.As I said the "Y" leds on the breakout board wont light
when jumpered from signal to ground as they should no matter how Mach
is configured....-Unless I still am in error someplace, which is
possible....
Steven
wrote:
> Steve,they can switch themselves in Mach from active low to high and vice
>
> I've noticed sometimes when switching things around on inputs that
versa. Estop circuits can do this on pin 10 if not wired correctly.
>Ron, I have had some trouble working from the bit of literature given
> Ron
>
on limit switchs with Mach2 and the Campbell breakout board..I think I
finally have it figured out but the damage is now done..I'll end up
using "A" axis terminals for the "Y" until I get this board repaired or
I replace it.As I said the "Y" leds on the breakout board wont light
when jumpered from signal to ground as they should no matter how Mach
is configured....-Unless I still am in error someplace, which is
possible....
Steven
Discussion Thread
alphawolf45
2005-08-16 18:01:42 UTC
proximity sensor
Robert Campbell
2005-08-16 18:11:22 UTC
Re: [CAD_CAM_EDM_DRO] proximity sensor
Robert Campbell
2005-08-16 18:16:32 UTC
Re: [CAD_CAM_EDM_DRO] proximity sensor
JCullins
2005-08-16 18:42:12 UTC
Re: [CAD_CAM_EDM_DRO] proximity sensor
alphawolf45
2005-08-16 19:22:43 UTC
Re: proximity sensor
alphawolf45
2005-08-20 10:24:28 UTC
Re: proximity sensor
R Rogers
2005-08-20 10:31:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: proximity sensor
alphawolf45
2005-08-20 10:45:38 UTC
Re: proximity sensor