Re: [CAD_CAM_EDM_DRO] anyone knows a good source for
Posted by
Codesuidae
on 2005-09-17 09:22:11 UTC
The purpose of microstepping is not to increase resolution but to reduce
resonance problems.
At least thats they way its been explained to me.
Dave
juan gelt wrote:
resonance problems.
At least thats they way its been explained to me.
Dave
juan gelt wrote:
>as long as the topic arises, i have a question on the
>actual performance of a microstepping controller vs
>not.
>
>let's say the native resolution of a stepper is 200
>steps/rev. the error would be +- 1/2 step. so i can
>see half steps being somewhat realistic. but as one
>attempts to position a rotor between those teeth based
>on analog voltage of the coils, i have doubts as to
>how accurate those can turn out to be on different
>motors under different loads. in fact, it seems
>downright spurious.
>
>
Discussion Thread
ink_shit
2005-09-16 18:31:15 UTC
anyone knows a good source for
turbulatordude
2005-09-16 18:39:43 UTC
Re: anyone knows a good source for
Aaron
2005-09-16 19:21:49 UTC
Re: [CAD_CAM_EDM_DRO] anyone knows a good source for
JanRwl@A...
2005-09-16 21:42:57 UTC
Re: [CAD_CAM_EDM_DRO] anyone knows a good source for
juan gelt
2005-09-17 08:41:06 UTC
Re: [CAD_CAM_EDM_DRO] anyone knows a good source for
Codesuidae
2005-09-17 09:22:11 UTC
Re: [CAD_CAM_EDM_DRO] anyone knows a good source for
bulshatar
2005-09-17 15:17:42 UTC
Re: anyone knows a good source for
juan gelt
2005-09-17 16:26:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: anyone knows a good source for
John Dammeyer
2005-09-18 21:00:48 UTC
RE: [CAD_CAM_EDM_DRO] anyone knows a good source for