Re: anyone knows a good source for
Posted by
bulshatar
on 2005-09-17 15:17:42 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, juan gelt <juangelt@y...>
wrote:
of the motors and acceleration throught resonance bands. I have two
edentical steppers on a gantry router, one with a half-step driver
and the other with a microstepping Gecko. There is no comparison
between the two. The motor with the Gecko sounds almost like a servo.
Hope this helps,
John
wrote:
>Yes, it works! Not so much for improved resolution but for smoothness
> as long as the topic arises, i have a question on the
> actual performance of a microstepping controller vs
> not.
>
> let's say the native resolution of a stepper is 200
> steps/rev. the error would be +- 1/2 step. so i can
> see half steps being somewhat realistic. but as one
> attempts to position a rotor between those teeth based
> on analog voltage of the coils, i have doubts as to
> how accurate those can turn out to be on different
> motors under different loads. in fact, it seems
> downright spurious.
>
> so is there anyone with actual experience using both
> types who can testify?
> does the part that comes off a machine with
> microstepping control in any way differ from the part
> that comes off the machine using 1/2 steps or single
> steps?
>
> plz, no theory - i get that part - does it work? and
> if so how well and in what respects - just smoother?
>
>
>
of the motors and acceleration throught resonance bands. I have two
edentical steppers on a gantry router, one with a half-step driver
and the other with a microstepping Gecko. There is no comparison
between the two. The motor with the Gecko sounds almost like a servo.
Hope this helps,
John
Discussion Thread
ink_shit
2005-09-16 18:31:15 UTC
anyone knows a good source for
turbulatordude
2005-09-16 18:39:43 UTC
Re: anyone knows a good source for
Aaron
2005-09-16 19:21:49 UTC
Re: [CAD_CAM_EDM_DRO] anyone knows a good source for
JanRwl@A...
2005-09-16 21:42:57 UTC
Re: [CAD_CAM_EDM_DRO] anyone knows a good source for
juan gelt
2005-09-17 08:41:06 UTC
Re: [CAD_CAM_EDM_DRO] anyone knows a good source for
Codesuidae
2005-09-17 09:22:11 UTC
Re: [CAD_CAM_EDM_DRO] anyone knows a good source for
bulshatar
2005-09-17 15:17:42 UTC
Re: anyone knows a good source for
juan gelt
2005-09-17 16:26:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: anyone knows a good source for
John Dammeyer
2005-09-18 21:00:48 UTC
RE: [CAD_CAM_EDM_DRO] anyone knows a good source for