Re: [CAD_CAM_EDM_DRO] Servo amplifier boards.

Yes, I meant shield - brain fart.

Is there a trick to getting the amplifiers to work? I have turned and
adjusted until my fingers hurt! I can get the amp adjusted so that it
doesn't "drift," but it won't do anything else, either. When I try to jog, I
get the Following error. At one point, I had the Y axis kind of working, but
that was a few days ago. I've managed to zing the table back and forth a few
times (and even smack it pretty hard), but there is no method to my madness.
Is there a general guideline to follow (eg. adjust signal to a certain point
then tach and then comp) or anything I should be looking for? Also, do I
need to have the PID values setup for this? Thanks.

-John