CAD CAM EDM DRO - Yahoo Group Archive

Re: cnc lathe/mill

Posted by stockley0883
on 2005-12-13 13:50:13 UTC
I have just bought a fully functional Hardinge TFB for under $2400
specifically for converting to CNC. The TFB is less desirable than the
HLV-H because it has no screw cutting gearbox (not needed for CNC
anyway). By the time I sell all the electrics, the compound slide and
some of the saddle drive mechanisms I may get another $300 to $500
back. So for under $2000 I have a lathe that is in a different league
to the ones you are looking at.

I plan on fitting servos with Rutex drivers. I need it for precision
work so I will be fitting ground ballscrews. I also want to get
constant surface speed and a slower bottom speed (125rpm is the limit)
so I will be replacing the 2 speed motor with a 2hp vector drive. This
gives me 100% torque all the way from 0 rpm up. However, this is an
expensive luxury you could add later if required.

Paul

Discussion Thread

jak785 2005-12-09 19:04:21 UTC cnc lathe/mill turbulatordude 2005-12-09 21:22:19 UTC Re: cnc lathe/mill jak785 2005-12-10 18:27:06 UTC Re: cnc lathe/mill ED MAISEY 2005-12-10 18:58:26 UTC Re: [CAD_CAM_EDM_DRO] Re: cnc lathe/mill jak785 2005-12-10 19:53:18 UTC Re: cnc lathe/mill C.S. Mo 2005-12-10 23:36:56 UTC Re: [CAD_CAM_EDM_DRO] Re: cnc lathe/mill jak785 2005-12-11 18:56:19 UTC Re: cnc lathe/mill C.S. Mo 2005-12-11 20:37:50 UTC Re: [CAD_CAM_EDM_DRO] Re: cnc lathe/mill Vaso 2005-12-11 20:40:55 UTC Re: cnc lathe/mill | SIEG C6B & Super X3 | Golmatic MD23 Raymond Heckert 2005-12-11 21:49:05 UTC Re: [CAD_CAM_EDM_DRO] Re: cnc lathe/mill wthomas@g... 2005-12-12 21:25:01 UTC Re: [CAD_CAM_EDM_DRO] Re: cnc lathe/mill vrsculptor 2005-12-13 08:23:04 UTC Re: cnc lathe/mill | SIEG C6B & Super X3 | Golmatic MD23 Vaso 2005-12-13 08:52:38 UTC Re: | Golmatic MD23 | Myford Connoisseur | South Bend stockley0883 2005-12-13 13:50:13 UTC Re: cnc lathe/mill jak785 2005-12-13 17:41:09 UTC Re: cnc lathe/mill Vaso 2005-12-13 19:27:42 UTC Re: cnc lathe/mill | SIEG Machines Raymond Heckert 2005-12-13 21:24:07 UTC Re: [CAD_CAM_EDM_DRO] Re: cnc lathe/mill