Re: [CAD_CAM_EDM_DRO] Re: Problem keeping my gantry square, using a dual drive (SOLVED)
Posted by
Peter Megan Isabella
on 2006-02-13 01:34:38 UTC
> Just an FYI since Peter "scatter shoots" his posts across multipleCaudlet,
> lists: He rerouted some motor wires and the problem went away. I
> suggested early on over on my support list (of which he is also a
> member) that one possiblity was noise. He posted some pictures of
> cuts (on yet another list) so it looks like he got through that part
> of the ordeal. I wanted the list to know what the soltuion was since
> it may help future builders.
>
Yes I am a "scatter shooter". I this so that I can get as much information
as quickly as possible. Because it was not really a question just to do
with plasma cuttting I posted it at a few sites. I will have to make sure
that I end posts and not just leave them hanging. These forums are really
great! There is heaps of information out there to take in.
Peter
Australia
Discussion Thread
apples0_17
2006-02-11 02:55:41 UTC
Problem keeping my gantry square, using a dual drive slaved set-up with Geckos.
afn09556
2006-02-11 10:26:51 UTC
Re: Problem keeping my gantry square, using a dual drive slaved set-up with Geck
John Dammeyer
2006-02-11 10:35:43 UTC
RE: [CAD_CAM_EDM_DRO] Problem keeping my gantry square, using a dual drive slaved set-up with Gecko's.
Doug Fortune
2006-02-11 20:28:09 UTC
Re: Problem keeping my gantry square
jcc3inc
2006-02-12 07:16:15 UTC
Re: Problem keeping my gantry square, using a dual drive slaved set-up with Geckos.
caudlet
2006-02-12 09:54:13 UTC
Re: Problem keeping my gantry square, using a dual drive (SOLVED)
Peter Megan Isabella
2006-02-13 01:34:38 UTC
Re: [CAD_CAM_EDM_DRO] Re: Problem keeping my gantry square, using a dual drive (SOLVED)
turbulatordude
2006-02-13 05:43:52 UTC
Re: Problem keeping my gantry square, using a dual drive (SOLVED)