CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] : Lathe solid model to G code

Posted by wanliker@a...
on 2006-03-26 15:15:02 UTC
In a message dated 3/26/2006 4:09:00 PM Mountain Standard Time,
lesnewell@... writes:

It
can be frustrating to set up at times but once you have beaten it into
submission it produces good code.



Where do I get a big stick cheaply????????????
bill


[Non-text portions of this message have been removed]

Discussion Thread

wanliker@a... 2006-03-23 18:49:55 UTC : Lathe solid model to G code Alan Marconett 2006-03-24 09:05:06 UTC RE: [CAD_CAM_EDM_DRO] : Lathe solid model to G code wanliker@a... 2006-03-26 14:08:47 UTC : Lathe solid model to G code wanliker@a... 2006-03-26 14:13:56 UTC : Lathe solid model to G code R Rogers 2006-03-26 14:38:59 UTC Re: [CAD_CAM_EDM_DRO] : Lathe solid model to G code Dhiren Shah 2006-03-26 14:41:08 UTC RE: [CAD_CAM_EDM_DRO] : Lathe solid model to G code wanliker@a... 2006-03-26 14:53:54 UTC Re: [CAD_CAM_EDM_DRO] : Lathe solid model to G code Les Newell 2006-03-26 15:07:57 UTC Re: [CAD_CAM_EDM_DRO] : Lathe solid model to G code wanliker@a... 2006-03-26 15:15:02 UTC Re: [CAD_CAM_EDM_DRO] : Lathe solid model to G code Les Newell 2006-03-26 15:37:07 UTC Re: [CAD_CAM_EDM_DRO] : Lathe solid model to G code