Re: [CAD_CAM_EDM_DRO] : Lathe solid model to G code
Posted by
Les Newell
on 2006-03-26 15:37:07 UTC
I forgot to give a link to Dolphin Partmaster
<http://www.dolphin.zenwebhosting.com/dcamturn.htm>. For turning you
need their level2 package which is 395 UK pounds (688 US dollars). Not
exactly cheap but still far cheaper than most.
Les
wanliker@... wrote:
<http://www.dolphin.zenwebhosting.com/dcamturn.htm>. For turning you
need their level2 package which is 395 UK pounds (688 US dollars). Not
exactly cheap but still far cheaper than most.
Les
wanliker@... wrote:
>
> In a message dated 3/26/2006 4:09:00 PM Mountain Standard Time,
> lesnewell@... writes:
>
> It
> can be frustrating to set up at times but once you have beaten it into
> submission it produces good code.
>
>
>
> Where do I get a big stick cheaply????????????
> bill
>
>
> [Non-text portions of this message have been removed]
>
>
Discussion Thread
wanliker@a...
2006-03-23 18:49:55 UTC
: Lathe solid model to G code
Alan Marconett
2006-03-24 09:05:06 UTC
RE: [CAD_CAM_EDM_DRO] : Lathe solid model to G code
wanliker@a...
2006-03-26 14:08:47 UTC
: Lathe solid model to G code
wanliker@a...
2006-03-26 14:13:56 UTC
: Lathe solid model to G code
R Rogers
2006-03-26 14:38:59 UTC
Re: [CAD_CAM_EDM_DRO] : Lathe solid model to G code
Dhiren Shah
2006-03-26 14:41:08 UTC
RE: [CAD_CAM_EDM_DRO] : Lathe solid model to G code
wanliker@a...
2006-03-26 14:53:54 UTC
Re: [CAD_CAM_EDM_DRO] : Lathe solid model to G code
Les Newell
2006-03-26 15:07:57 UTC
Re: [CAD_CAM_EDM_DRO] : Lathe solid model to G code
wanliker@a...
2006-03-26 15:15:02 UTC
Re: [CAD_CAM_EDM_DRO] : Lathe solid model to G code
Les Newell
2006-03-26 15:37:07 UTC
Re: [CAD_CAM_EDM_DRO] : Lathe solid model to G code