CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: need axis design idea

Posted by wanliker@a...
on 2006-04-16 10:38:57 UTC
In a message dated 4/16/2006 11:17:49 AM Mountain Daylight Time,
gtravis1@... writes:

Another plan might be to have a PC board made with the pattern for
a digital
> caliper on it; the pattern could be repeated a lot of times across
the width
> of the board, then cut up into strips and assembled end to end to
make a
> long travel. If this works I'll report back here.



There was a project in one of the home shop magazines several years ago,
where a guy did just exactly thing, making his own long travel caliper beams.
Sorry, I don't remember the magazine or the article name.
bill


[Non-text portions of this message have been removed]

Discussion Thread

Elliot Burke 2006-04-10 21:04:01 UTC need axis design idea wthomas@g... 2006-04-10 21:23:24 UTC W.E.T.Re: [CAD_CAM_EDM_DRO] need axis design idea wanliker@a... 2006-04-10 22:56:22 UTC need axis design idea wanliker@a... 2006-04-10 23:35:43 UTC need axis design idea davegsc@t... 2006-04-11 09:11:20 UTC RE: [CAD_CAM_EDM_DRO] need axis design idea shadi_salhab_78 2006-04-11 23:26:58 UTC Re: need axis design idea wanliker@a... 2006-04-11 23:37:38 UTC Re: [CAD_CAM_EDM_DRO] Re: need axis design idea Graham Stabler 2006-04-12 02:46:41 UTC Re: need axis design idea juan gelt 2006-04-12 05:35:40 UTC Re: [CAD_CAM_EDM_DRO] Re: need axis design idea Graham Stabler 2006-04-12 11:27:00 UTC Re: need axis design idea Elliot Burke 2006-04-15 19:18:23 UTC re: RE: need axis design idea G L Travis 2006-04-16 10:16:10 UTC Re: need axis design idea wanliker@a... 2006-04-16 10:38:57 UTC Re: [CAD_CAM_EDM_DRO] Re: need axis design idea G L Travis 2006-04-16 11:08:58 UTC Re: need axis design idea Lester Caine 2006-04-16 16:05:49 UTC Re: [CAD_CAM_EDM_DRO] Re: need axis design idea Graham Stabler 2006-04-16 17:03:59 UTC Re: need axis design idea juan gelt 2006-04-16 18:50:33 UTC Re: [CAD_CAM_EDM_DRO] Re: need axis design idea Lester Caine 2006-04-16 23:24:10 UTC Re: [CAD_CAM_EDM_DRO] Re: need axis design idea juangelt 2006-04-17 00:59:46 UTC Re: need axis design idea