: linear bearing based on ground flat stock
Posted by
wanliker@a...
on 2006-05-22 20:41:43 UTC
In a message dated 5/22/2006 9:04:40 P.M. Mountain Daylight Time,
ballendo@... writes:
It would even be possible to turn the square into a flat with vee
edges. (put it in a couple of vee blocks on a mill and go to town!<G>
Or a piece of rectangular ground flat stock, placed in the same V blocks,
four cuts later it would be a flattened Hexagon, and mount it from the side,
and V pulleys on the top and the bottom. Same effect, but more mounting
options.
This would give you guidance in all directions from two V pulleys.
Up, Down, Left, and Right
Or mount the pulleys on the frame, and the bar on the table.
In either case, you would have to have at least two sets of pulleys on each
side of the frame.
IMHO
bill
[Non-text portions of this message have been removed]
ballendo@... writes:
It would even be possible to turn the square into a flat with vee
edges. (put it in a couple of vee blocks on a mill and go to town!<G>
Or a piece of rectangular ground flat stock, placed in the same V blocks,
four cuts later it would be a flattened Hexagon, and mount it from the side,
and V pulleys on the top and the bottom. Same effect, but more mounting
options.
This would give you guidance in all directions from two V pulleys.
Up, Down, Left, and Right
Or mount the pulleys on the frame, and the bar on the table.
In either case, you would have to have at least two sets of pulleys on each
side of the frame.
IMHO
bill
[Non-text portions of this message have been removed]
Discussion Thread
wanliker@a...
2006-05-22 18:27:36 UTC
: linear bearing based on ground flat stock
wanliker@a...
2006-05-22 20:41:43 UTC
: linear bearing based on ground flat stock
Graham Stabler
2006-05-23 02:59:02 UTC
Re: : linear bearing based on ground flat stock
Fred Smith
2006-05-23 07:27:40 UTC
Re: : linear bearing based on ground flat stock
Graham Stabler
2006-05-23 07:52:48 UTC
Re: : linear bearing based on ground flat stock
Fred Smith
2006-05-23 09:22:38 UTC
Re: : linear bearing based on ground flat stock
turbulatordude
2006-05-23 10:39:17 UTC
Re: : linear bearing based on ground flat stock
wanliker@a...
2006-05-24 23:58:44 UTC
: linear bearing based on ground flat stock
Jack Hudler
2006-05-25 09:17:28 UTC
BOO!
lcdpublishing
2006-05-25 11:34:22 UTC
Re: BOO!
Dave Fisher
2006-05-25 11:55:36 UTC
RE: [CAD_CAM_EDM_DRO] Re: BOO!
lcdpublishing
2006-05-25 12:43:52 UTC
Re: BOO!
Ron Yost
2006-05-25 14:23:08 UTC
Speedy router video URL .. was:RE: [CAD_CAM_EDM_DRO] Re: BOO!