: linear bearing based on ground flat stock

In a message dated 5/24/2006 4:52:39 P.M. Mountain Daylight Time,
eexgs@... writes:

Just out of interest if I wanted to do some g-code for the v, other
than hand coding or excel spread sheeting it are there any FREE pieces
of software out there that can produce the toolpath? I'm thinking
somewhat generally not just for this job.



Check out this site, has various Wizards that will write code for you.

_http://www.ohmikron.com/_ (http://www.ohmikron.com/)

Check G-Code Tools, plus there are a lot of other things you might want to
pursue.
bill
CCED


[Non-text portions of this message have been removed]