CAD CAM EDM DRO - Yahoo Group Archive

Re: stepper EDM

on 2006-08-07 21:20:03 UTC
Graham,

http://www.users.qwest.net/~kmaxon/page/side/control17_137.htm

here's some work on stepper based EDM and a proportional gap input circuit.
This guy's site has been around for ages, & I just rediscovered it.
It has most of the circuits, but the code for the executable are not there.

regards,
TomP

Discussion Thread

Thomas J Powderly 2006-08-07 21:20:03 UTC Re: stepper EDM Graham Stabler 2006-08-08 02:11:07 UTC Re: stepper EDM Abby Katt 2006-08-08 03:45:09 UTC Lights and lenses, the poor mans laser? Graham Stabler 2006-08-08 04:17:42 UTC Re: Lights and lenses, the poor mans laser? lcdpublishing 2006-08-08 06:16:50 UTC Re: Vacuum Forming --- Was--->Lights and lenses, the poor mans laser? wthomas@g... 2006-08-08 07:41:24 UTC W.E.T. [CAD_CAM_EDM_DRO] Re: Vacuum Forming --- Was--->Lights and lenses, the poor mans laser? Graham Stabler 2006-08-08 10:42:55 UTC Re: Vacuum Forming --- Was--->Lights and lenses, the poor mans laser? lcdpublishing 2006-08-08 11:19:21 UTC Re: Vacuum Forming --- Was--->Lights and lenses, the poor mans laser?