Re: [CAD_CAM_EDM_DRO] 2 steppers-one axis?
Posted by
Alan Marconett KM6VV
on 2000-07-12 14:59:52 UTC
Terry,
There should be no problem, just feed the extra Y driver with the SAME
pulses as the current Y (or whatever) you want to duplicate (wire motor
for the same effective rotation).
http://www.super-tech.com/root/sc.htm "supercam" does this with his
"XYYZ Electronic Motor Controller".
There should be no problem, just feed the extra Y driver with the SAME
pulses as the current Y (or whatever) you want to duplicate (wire motor
for the same effective rotation).
http://www.super-tech.com/root/sc.htm "supercam" does this with his
"XYYZ Electronic Motor Controller".
> Terry Ackland wrote:
>
> I have a 3 axis stepper kit and just use the x and y axis and the 3rd
> motor is not connected.
> I was just wondering if I could use 2 steppers to drive one axis
> making it possible to have more available power in an axis that is
> almost direct drive? Would there be a problem with the x pulses not
> being in sync with the z pulses,or are they?
> Thanks in advance, before I start making brackets etc. Terry
>
Discussion Thread
Alan Marconett KM6VV
2000-07-12 14:59:52 UTC
Re: [CAD_CAM_EDM_DRO] 2 steppers-one axis?
Terry Ackland
2000-07-12 18:07:56 UTC
Re: 2 steppers-one axis?
Mariss Freimanis
2000-07-12 21:44:16 UTC
Re: 2 steppers-one axis?
Jon Elson
2000-07-12 22:01:21 UTC
Re: [CAD_CAM_EDM_DRO] 2 steppers-one axis?
Alan Marconett KM6VV
2000-07-13 10:57:05 UTC
Re: [CAD_CAM_EDM_DRO] 2 steppers-one axis?
James Cullins
2000-07-13 16:24:56 UTC
Re: [CAD_CAM_EDM_DRO] 2 steppers-one axis?