Re: [CAD_CAM_EDM_DRO] Re: Re: Gecko, fuses on the power or not ?

Posted by WT

on 2006-10-03 05:08:13 UTC

Hi John,

I believe you can set the Chinese stepper driver to 10 microsteps. Even the arceurotrade website indicates so.

I am using the same Chinese stepper driver set at 10 microsteps.

Weedy

----- Original Message -----
From: John Stevenson
To: CAD_CAM_EDM_DRO@...
Sent: Tuesday, October 03, 2006 7:24 PM
Subject: [CAD_CAM_EDM_DRO] Re: Re: Gecko, fuses on the power or not ?

> henrikolsson2001 wrote:
>
> > Hi John,
> > What chinese drive, if you don't mind me asking? Website? Anything?
>
> http://www.arceurotrade.co.uk/en-gb/dept_144.html at the bottom.
>
> John - why didn't you set it for 10 steps?
>
> --
> Lester Caine -

Because they are 2,4,8,16, etc increments on these drives.

John S.

[Non-text portions of this message have been removed]

Discussion Thread