Re: [CAD_CAM_EDM_DRO] limit switches

all electronics --
http://www.allelectronics.com/
make sure you require the full stroke to work them-- I use the
roller type.

good luck

jesse

On Oct 10, 2006, at 12:40 PM, Mike Fredricks wrote:

Anyone have a source for some good limit switches that are reasonably
priced. I've been having problems with the 2 types of micro switches
that I've had so far. I run them normally closed and vibration from
the machine intermittently bumps them open and faults my geckos and
wrecks my part. I've been just running with the switches disconnected
and all works well. I found that if I wrap the machine with a
screwdriver handle near the switches this creates the fault a lot of
the time.

Thanks

[Non-text portions of this message have been removed]






[Non-text portions of this message have been removed]