Need to commission a job
Posted by
justinasia
on 2006-11-17 07:52:07 UTC
Moderators note :
Please respond OFF LIST if you want to discuss this project.
But, if you have links to where he could go, that would be OK to post on-list.
==============================================
Hi everyone,
I need some tools made, and I do not know where to look. I am hoping
that some of you may be able to point me to who I could get to make
these tools.
I need a set of gauges to measure pipe diameter. The method is to have
round disks attached to the end of a rod, and then I insert that into
a tapered pipe, so I can measure when it stops. The rod is attached to
the flat side of the disk, so the disk is like a cross section of the pipe.
So, these disks are made with a lathe. I need a set of them.
-Thickness = 3mm. accuracy not so important. About 3mm.
-Diameter from 10mm to 30mm, in 0.1mm increments (ie 10.0, 10.1, 10.2,
10.3 etc). Tolerance should be plus or minus 0.01mm
-Each disk has a hole through the middle, threaded so it can attach to
a rod. Needs to be straight.
-Material = stainless steel.
If anyone would have an idea to how much this would cost, how long it
would take to make and where I can get it done, I would be very grateful.
Thank you
Justin
-> REMEMBER - job related responses - OFF-LIST <-
Please respond OFF LIST if you want to discuss this project.
But, if you have links to where he could go, that would be OK to post on-list.
==============================================
Hi everyone,
I need some tools made, and I do not know where to look. I am hoping
that some of you may be able to point me to who I could get to make
these tools.
I need a set of gauges to measure pipe diameter. The method is to have
round disks attached to the end of a rod, and then I insert that into
a tapered pipe, so I can measure when it stops. The rod is attached to
the flat side of the disk, so the disk is like a cross section of the pipe.
So, these disks are made with a lathe. I need a set of them.
-Thickness = 3mm. accuracy not so important. About 3mm.
-Diameter from 10mm to 30mm, in 0.1mm increments (ie 10.0, 10.1, 10.2,
10.3 etc). Tolerance should be plus or minus 0.01mm
-Each disk has a hole through the middle, threaded so it can attach to
a rod. Needs to be straight.
-Material = stainless steel.
If anyone would have an idea to how much this would cost, how long it
would take to make and where I can get it done, I would be very grateful.
Thank you
Justin
-> REMEMBER - job related responses - OFF-LIST <-
Discussion Thread
justinasia
2006-11-17 07:52:07 UTC
Need to commission a job
pandya amit
2006-11-17 10:35:01 UTC
Re: [CAD_CAM_EDM_DRO] Need to commission a job
turbulatordude
2006-11-18 05:47:50 UTC
Re: Need to commission a job
Justin .
2006-11-18 14:43:39 UTC
Re: [CAD_CAM_EDM_DRO] Re: Need to commission a job