CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] hydrapath 3 data transmission ???

Posted by Jon Elson
on 2007-02-09 20:32:23 UTC
rogersmach wrote:

>Sorry for the OT, does anyone have experience with transmitting data
>from a PC through an RS232 serial port and a hydrapath 3 cnc
>controller.
>
>Have one and can't get it to receive from the PC. Tried every setting
>we could. Confused about how to set the controller to accept data. Is
>the cable used standard or special. Any help with this will be greatly
>appreciated.
>
>
Are you sure it takes ASCII? Some of the really old controls only accepted
EIA code, or could be ordered with one or the other, not both. If it had a
6-channel paper tape reader, that infers EIA code only.

Jon

Discussion Thread

rogersmach 2007-02-09 14:34:51 UTC hydrapath 3 data transmission ??? David Speck 2007-02-09 15:29:54 UTC Re: [CAD_CAM_EDM_DRO] hydrapath 3 data transmission ??? caudlet 2007-02-09 16:26:08 UTC Re: hydrapath 3 data transmission ??? R Rogers 2007-02-09 18:30:49 UTC Re: [CAD_CAM_EDM_DRO] Re: hydrapath 3 data transmission ??? Jon Elson 2007-02-09 20:32:23 UTC Re: [CAD_CAM_EDM_DRO] hydrapath 3 data transmission ??? R Rogers 2007-02-10 05:22:43 UTC Re: [CAD_CAM_EDM_DRO] hydrapath 3 data transmission ??? Jon Elson 2007-02-10 11:31:18 UTC Re: [CAD_CAM_EDM_DRO] hydrapath 3 data transmission ??? R Rogers 2007-02-10 12:24:06 UTC Re: [CAD_CAM_EDM_DRO] hydrapath 3 data transmission ???