Re: [CAD_CAM_EDM_DRO] Repeatability of microswitches

Hi Ian,

Fine, you figure out where to put the sensors (on a Sherline/Sears Mill
for me), and I'll be working out the electronics for the MAXNC
stepper/driver kit. Should also work on other stepper retrofits.

Alan

Ian Wright wrote:

>
> Hi Alan,
>
> I like this idea but I'm not sure I'm clever enough to implement it. When
> you have designed the circuit will you post a .gif of it somewhere so I can
> take a look please?
>
> Ian
>
> --
> Ian W. Wright
> Sheffield UK
>
> ----- Original Message -----
> From: Alan Marconett KM6VV <KM6VV@...>
>
> >I'm thinking about using a photo
> > interrupter, and AND the signal with a phase from the stepper. This
> > narrows the "width" of the home. Now, where to put them?
> >
>
> ------------------------------------------------------------------------
> Wish you had something rad to add to your email?
> We do at www.supersig.com.
> http://click.egroups.com/1/6810/4/_/423600/_/964271149/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager