upgrade cnc
Posted by
billhribar
on 2007-04-16 12:08:27 UTC
Hi all:
I am upgrading a small cnc to a more powerful cnc and am using mach-3.
what I need to know is how to interface the PWM signal from mach-3 to
drive my 12 volt DC motor. You can't just connect the output of the
parallrl port to a mosfet driver, can you??? what kind of circuit do i
need? Anyone?
thanks:
Bill
I am upgrading a small cnc to a more powerful cnc and am using mach-3.
what I need to know is how to interface the PWM signal from mach-3 to
drive my 12 volt DC motor. You can't just connect the output of the
parallrl port to a mosfet driver, can you??? what kind of circuit do i
need? Anyone?
thanks:
Bill
Discussion Thread
billhribar
2007-04-16 12:08:27 UTC
upgrade cnc
Bob Campbell
2007-04-16 16:40:55 UTC
Re: [CAD_CAM_EDM_DRO] upgrade cnc
ballendo
2007-04-16 17:02:53 UTC
Re: upgrade cnc
bill hribar
2007-04-17 09:12:37 UTC
Re: [CAD_CAM_EDM_DRO] upgrade cnc
Bob Campbell
2007-04-17 10:37:48 UTC
Re: [CAD_CAM_EDM_DRO] upgrade cnc
Mark Vaughan
2007-04-17 13:02:43 UTC
RE: [CAD_CAM_EDM_DRO] upgrade cnc