Tapmatic 30TC/DC 1/2" Arbor
Posted by
Peter Homann
on 2007-05-07 19:04:34 UTC
Hi,
I'm planning to try and mount a Tapmatic 30TC/DC tapping head on a Taig
CNC mill.
My plan is to mount the head beside the standard mill head, using a
bracket mounted to the T-Slots in the Mill head. The bracket will contain
a couple of bearing blocks for 2 x 1/2 ID bearing.
The idea is that the bearing will hold the Tapmatic 1/2 arbor. a Taig 1/2"
ID pulley block will then sit on top. I'll then run a large Taig Gates
belt from the motor to the pulley.
With this setup I'll get about the same Z clearance as the standard mill
head. My only concern is that the tapping head will be off centre by a
couple of inches. But then the Taig is a tough little beast.
So does anyone know where I can get a Tapmatic 1/2" arbor in good
condition, for a reasonable price? I'm also happy to barter the products I
sell.
Also any comments on my planned setup would be helpful.
Cheers,
Peter.
I'm planning to try and mount a Tapmatic 30TC/DC tapping head on a Taig
CNC mill.
My plan is to mount the head beside the standard mill head, using a
bracket mounted to the T-Slots in the Mill head. The bracket will contain
a couple of bearing blocks for 2 x 1/2 ID bearing.
The idea is that the bearing will hold the Tapmatic 1/2 arbor. a Taig 1/2"
ID pulley block will then sit on top. I'll then run a large Taig Gates
belt from the motor to the pulley.
With this setup I'll get about the same Z clearance as the standard mill
head. My only concern is that the tapping head will be off centre by a
couple of inches. But then the Taig is a tough little beast.
So does anyone know where I can get a Tapmatic 1/2" arbor in good
condition, for a reasonable price? I'm also happy to barter the products I
sell.
Also any comments on my planned setup would be helpful.
Cheers,
Peter.
Discussion Thread
Peter Homann
2007-05-07 19:04:34 UTC
Tapmatic 30TC/DC 1/2" Arbor
ballendo
2007-05-08 00:50:03 UTC
Re: Tapmatic 30TC/DC 1/2" Arbor
Peter Homann
2007-05-08 01:15:56 UTC
Re: [CAD_CAM_EDM_DRO] Re: Tapmatic 30TC/DC 1/2" Arbor
ballendo
2007-05-08 01:59:49 UTC
Re: Tapmatic 30TC/DC 1/2" Arbor
Peter Homann
2007-05-08 05:24:50 UTC
Re: [CAD_CAM_EDM_DRO] Re: Tapmatic 30TC/DC 1/2" Arbor