Re: IMService releases ncPOD system

--- In CAD_CAM_EDM_DRO@yahoogroups.com, Tony Jeffree <tony@...> wrote:

>
> At 14:49 23/05/2007, Fred Smith wrote:
> >Mach3 can run an ncPOD through a plugin developed by Art Fenerty, it

is

> >considered released.
>
> By whom (apart from you, that is)?
>
> To the best of my knowledge MACH support for the 'pod is still
> regarded by Art as *pre-release*. See:

nice. Are you a moderator there? Funny it said full release until I
released my hardware system. Too bad Art's on vacation or I would ask
him to comment about what games are afoot.

Try this link:

http://groups.yahoo.com/group/mach1mach2cnc/message/73372

Quite clearly Art considered it in full release on April 25.

Fred Smith - IMService