CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: IMService releases ncPOD system

Posted by Tony Jeffree
on 2007-05-23 11:49:41 UTC
At 14:49 23/05/2007, Fred Smith wrote:
>Mach3 can run an ncPOD through a plugin developed by Art Fenerty, it is
>considered released.

By whom (apart from you, that is)?

To the best of my knowledge MACH support for the 'pod is still
regarded by Art as *pre-release*. See:

http://www.artsoftcontrols.com/artsoft/plugin.htm


Regards,
Tony

Discussion Thread

Fred Smith 2007-05-18 07:56:46 UTC IMService releases ncPOD system Bill 2007-05-22 10:59:55 UTC Re: IMService releases ncPOD system [moderator notes] Fred Smith 2007-05-23 06:52:59 UTC Re: IMService releases ncPOD system Tony Jeffree 2007-05-23 07:19:48 UTC Re: [CAD_CAM_EDM_DRO] Re: IMService releases ncPOD system Fred Smith 2007-05-23 08:20:23 UTC Re: IMService releases ncPOD system Tony Jeffree 2007-05-23 09:01:01 UTC Re: [CAD_CAM_EDM_DRO] Re: IMService releases ncPOD system Tony Jeffree 2007-05-23 10:46:11 UTC Re: [CAD_CAM_EDM_DRO] Re: IMService releases ncPOD system Fred Smith 2007-05-23 10:54:22 UTC Re: IMService releases ncPOD system Fred Smith 2007-05-23 11:09:28 UTC Re: IMService releases ncPOD system Lester Caine 2007-05-23 11:28:19 UTC Re: [CAD_CAM_EDM_DRO] Re: IMService releases ncPOD system Tony Jeffree 2007-05-23 11:49:41 UTC Re: [CAD_CAM_EDM_DRO] Re: IMService releases ncPOD system Tony Jeffree 2007-05-23 12:26:30 UTC Re: [CAD_CAM_EDM_DRO] Re: IMService releases ncPOD system Fred Smith 2007-05-23 13:09:52 UTC Re: IMService releases ncPOD system Steve Blackmore 2007-05-23 14:18:22 UTC Re: [CAD_CAM_EDM_DRO] Re: IMService releases ncPOD system Tony Jeffree 2007-05-23 15:21:22 UTC Re: [CAD_CAM_EDM_DRO] Re: IMService releases ncPOD system Lester Caine 2007-05-23 23:28:36 UTC Re: [CAD_CAM_EDM_DRO] Re: IMService releases ncPOD system Tony Jeffree 2007-05-24 02:14:35 UTC DeskCNC support for ncPOD art 2007-06-04 20:11:04 UTC Re: [CAD_CAM_EDM_DRO] Re: IMService releases ncPOD system Steve Blackmore 2007-06-05 14:09:47 UTC Re: [CAD_CAM_EDM_DRO] Re: IMService releases ncPOD system