Re: [CAD_CAM_EDM_DRO] Re: Spindle motors

R Rogers wrote:

>R/C hobby motors are designed for high output for short bursts and not many iterations. Run for 5 minutes, cool for 30. They are stripped down all out hot rods. It'd be like putting a 1/4 mile race engine in the family wagon. Wouldn't get far, but you'd get their in a hurry.
>
>

And don't forget the bearing loading. A mill has high side loads, an RC
motor has high axial loads. I suspect the bearings would last about 17
seconds in a milling application. :)

- Steve