Re: [CAD_CAM_EDM_DRO] Re: Spindle motors
Posted by
David G. LeVine
on 2007-08-29 19:33:35 UTC
At 10:42 AM 8/29/2007, you wrote:
belt with little load, the spindle handles the high radial and axial loads.
The bearing longevity might surprise you. Maybe even several
projects worth! :)
David G. LeVine
Nashua, NH 03060
>And don't forget the bearing loading. A mill has high side loads, an RCActually, the spindle motor usually runs direct drive or a toothed
>motor has high axial loads. I suspect the bearings would last about 17
>seconds in a milling application. :)
belt with little load, the spindle handles the high radial and axial loads.
The bearing longevity might surprise you. Maybe even several
projects worth! :)
David G. LeVine
Nashua, NH 03060
Discussion Thread
ccosentino2001
2007-08-28 16:58:57 UTC
siemens program repeat
David G. LeVine
2007-08-28 19:11:26 UTC
Spindle motors
Michael Fagan
2007-08-28 19:32:30 UTC
Re: [CAD_CAM_EDM_DRO] Spindle motors
David G. LeVine
2007-08-28 19:43:33 UTC
Re: [CAD_CAM_EDM_DRO] Spindle motors
caudlet
2007-08-29 06:00:13 UTC
Re: Spindle motors
R Rogers
2007-08-29 07:28:33 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle motors
Stephen Wille Padnos
2007-08-29 07:42:48 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle motors
David G. LeVine
2007-08-29 07:55:16 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle motors
Hugh Prescott
2007-08-29 09:11:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle motors
Jon Elson
2007-08-29 09:42:32 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle motors
William Perun Sr
2007-08-29 18:08:57 UTC
Re: Spindle motors
Michael Fagan
2007-08-29 18:16:51 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle motors
David G. LeVine
2007-08-29 19:33:35 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle motors
David G. LeVine
2007-08-29 19:34:43 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle motors
Graham Stabler
2007-08-30 00:55:45 UTC
Re: Spindle motors
Hugh Prescott
2007-08-30 07:45:47 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle motors