Re: Info for a Newbie -re stepper current
Posted by
stefan_sharpe
on 2007-09-10 18:03:49 UTC
Hannu,
Thanks again for the indepth reply. I obviously have a lot to learn-
but thats the challenge.
I`ll have a look around for some kits- i can see the sense in what you
are saying about getting something adequate to go from the start.
I am lucky in that nearby I have a very good electronics part shop-
I think I will take you up on your offer of the stepper motors too-
I`ll send you an email
Stefan
Thanks again for the indepth reply. I obviously have a lot to learn-
but thats the challenge.
I`ll have a look around for some kits- i can see the sense in what you
are saying about getting something adequate to go from the start.
I am lucky in that nearby I have a very good electronics part shop-
I think I will take you up on your offer of the stepper motors too-
I`ll send you an email
Stefan
Discussion Thread
stefan_sharpe
2007-09-07 07:33:21 UTC
Info for a Newbie
Arnie Minear
2007-09-07 08:47:01 UTC
Re: Info for a Newbie
hannu
2007-09-07 09:19:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: Info for a Newbie
stefan_sharpe
2007-09-09 15:54:19 UTC
Re: Info for a Newbie
Michael Fagan
2007-09-09 16:44:03 UTC
Re: [CAD_CAM_EDM_DRO] Re: Info for a Newbie
stefan_sharpe
2007-09-09 23:37:47 UTC
Re: Info for a Newbie
hannu
2007-09-10 06:04:08 UTC
Re: [CAD_CAM_EDM_DRO] Re: Info for a Newbie -re stepper current
stefan_sharpe
2007-09-10 18:03:49 UTC
Re: Info for a Newbie -re stepper current