Re: unipolar stepper and 5804
Posted by
bll_nlsn
on 2007-10-23 10:34:05 UTC
check here for DIY PIC programers:
http://www.kitsrus.com/pic.html
Bill
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Chuck Merja" <chuckm@...>
wrote:
http://www.kitsrus.com/pic.html
Bill
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Chuck Merja" <chuckm@...>
wrote:
>move with
> We have some salvaged unipolar (5 wire) steppers that we've made
> David Benson's 4 SPST, 4 diode manual unipolar tester. His nextstep was to
> build a board with either a PIC16C711 or PIC1F84 supplying phase,direction
> and full or ½ step info plus the step input (3 microsecond minimumtiming)
> to a UCN5804 translator/driver. We thought we had access to a PICwondering
> programmer that would program the 84, but alas we do not. SO I'm
> if we can just have switches to the phase (pin 9), ½ step (pin 10)and
> direction (pin 14) to control those items and dump a square wavefrom like a
> 555 to "step" (pin 11) to get the 5804 to "Control" the stepper.
>
> thanks
>
> Chuck Merja
> <http://www.srvscience.org> www.srvscience.org
>
>
>
> [Non-text portions of this message have been removed]
>
Discussion Thread
Chuck Merja
2007-10-22 13:54:56 UTC
unipolar stepper and 5804
bll_nlsn
2007-10-23 10:34:05 UTC
Re: unipolar stepper and 5804
Chuck Merja
2007-10-26 08:44:43 UTC
RE: [CAD_CAM_EDM_DRO] unipolar stepper and 5804
Chuck Merja
2007-10-26 09:02:00 UTC
RE: [CAD_CAM_EDM_DRO] unipolar stepper and 5804
Graham Stabler
2007-10-27 12:01:02 UTC
Re: unipolar stepper and 5804
Chuck Merja
2007-10-28 04:12:08 UTC
RE: [CAD_CAM_EDM_DRO] Re: unipolar stepper and 5804
Graham Stabler
2007-10-28 07:37:57 UTC
Re: unipolar stepper and 5804
David G. LeVine
2007-10-28 12:58:34 UTC
RE: [CAD_CAM_EDM_DRO] unipolar stepper and 5804
Graham Stabler
2007-10-28 14:44:46 UTC
Re: unipolar stepper and 5804