Re: [CAD_CAM_EDM_DRO] Re: not working!
Posted by
Bob Bachman
on 2000-08-03 20:11:28 UTC
Terry,
Carey is correct, you must have a signal ground from the port.
Use any pin # 18 thru 25 on the parallel port for signal ground.
Bob
At 10:57 PM 8/3/00 -0400, you wrote:
Carey is correct, you must have a signal ground from the port.
Use any pin # 18 thru 25 on the parallel port for signal ground.
Bob
At 10:57 PM 8/3/00 -0400, you wrote:
>Terry: I think that that may be your problem.You need a ground
>connection to the parallel port. To the metal part of the plug should
>work. That is the only way to complete your circuits.
>Carey
>
>Terry Ackland wrote:
>
>> ---
>> Cary,
>> no, I just have 6 wires. Step and direction for each axis.
>> Terry
>> In CAD_CAM_EDM_DRO@egroups.com, "Carey L. Culpepper" <mr.c@b...>
>> wrote:
>> > Terry: Do you have a ground wire on the parallel port?
>> > Carey
>>
Discussion Thread
Carey L. Culpepper
2000-08-03 18:19:36 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!
Terry Ackland
2000-08-03 19:19:27 UTC
Re: not working!
Carey L. Culpepper
2000-08-03 19:59:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!
Bob Bachman
2000-08-03 20:11:28 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!
Jon Elson
2000-08-03 22:18:55 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!
JanRwl@A...
2000-08-04 17:51:29 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!
JanRwl@A...
2000-08-04 17:55:33 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!
JanRwl@A...
2000-08-04 18:01:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!
Jon Elson
2000-08-05 10:26:27 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!
Jon Elson
2000-08-05 10:30:30 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!
Alan Marconett KM6VV
2000-08-05 10:35:55 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!
JanRwl@A...
2000-08-06 16:33:08 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!
JanRwl@A...
2000-08-06 16:39:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!
JanRwl@A...
2000-08-06 16:40:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!
Jon Elson
2000-08-06 21:53:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: not working!