Re: [CAD_CAM_EDM_DRO] Wire / Cable Type to use for a 180 oz / 1.66 amp stepper motor
Posted by
Michael Fagan
on 2008-03-08 18:30:47 UTC
18 Gauge works good for me, 24 volt, 2A/phase.
I made the mistake of using all white wire, I have since found surplus
12 conductor 18 gauge cable, which I plan to retrofit eventually.
I made the mistake of using all white wire, I have since found surplus
12 conductor 18 gauge cable, which I plan to retrofit eventually.
On Fri, Mar 7, 2008 at 8:40 PM, gldrpilot <dc812@...> wrote:
>
>
>
>
>
>
> What type (solid or stranded) and size (gauge) of wiring are most folks
> using to connect their stepper motors to the HobbyCNC boards?
>
> I just built one of the HobbyCNC 4 axis foam boards, and I will be
> running the stepper motors at or below 1.6 amps. My initial thought
> was to use some serial cables, but cutting one open, the gauge of the
> individual wires looks waaaay small.
>
> What has everyone else used, and what is a good source for what you
> used?
>
> Thanks
>
> DC
>
>
Discussion Thread
gldrpilot
2008-03-07 20:40:16 UTC
Wire / Cable Type to use for a 180 oz / 1.66 amp stepper motor
Paul Kelly
2008-03-07 23:06:27 UTC
RE: [CAD_CAM_EDM_DRO] Wire / Cable Type to use for a 180 oz / 1.66 amp stepper motor
Robert Colin Campbell
2008-03-08 06:51:16 UTC
Re: [CAD_CAM_EDM_DRO] Wire / Cable Type to use for a 180 oz / 1.66 amp stepper motor
markotime
2008-03-08 10:06:40 UTC
Re: Wire / Cable Type to use for a 180 oz / 1.66 amp stepper motor
Michael Fagan
2008-03-08 18:30:47 UTC
Re: [CAD_CAM_EDM_DRO] Wire / Cable Type to use for a 180 oz / 1.66 amp stepper motor
Chris Horne
2008-03-09 10:32:56 UTC
Re: Wire / Cable Type to use for a 180 oz / 1.66 amp stepper motor
Michael Fagan
2008-03-09 22:14:38 UTC
Re: [CAD_CAM_EDM_DRO] Re: Wire / Cable Type to use for a 180 oz / 1.66 amp stepper motor