Re: [CAD_CAM_EDM_DRO] Mini-Mill ball screws/nuts AND CNC Router project

Dan, Found it, seems that Yahoo messes with the address. Jack

Dan Mauch <dmauch@...> wrote: try www.camtronics-cnc.com
Dan Mauch
economical 3D scanner software and kits
low cost stepper and servo motors.
cases for Gecko drives
kits and assembled 3-4 axis drives
www.camtronics-cnc.com
www.seanet.com/~dmauch

----- Original Message -----
From: Jack McKie
To: CAD_CAM_EDM_DRO@yahoogroups.com
Sent: Monday, June 02, 2008 5:20 PM
Subject: Re: [CAD_CAM_EDM_DRO] Mini-Mill ball screws/nuts AND CNC Router project

Dan,

Tried to reach your website w/o success?

Jack

Dan Mauch <dmauch@...> wrote:
No the base is all aluminum extrustions. I just layed a piece of mdf between the aluminum extrusion as a work top. The top is removable so I can mount a plasma cutter on the Z axis
The G251 work at 18VDC-50VDC
Since that video was taken I have redone the cable carryers as I didn't them incorrectly.
Dan Mauch
economical 3D scanner software and kits
low cost stepper and servo motors.
cases for Gecko drives
kits and assembled 3-4 axis drives
www.camtronics-cnc.com
www.seanet.com/~dmauch

[Non-text portions of this message have been removed]

[Non-text portions of this message have been removed]

[Non-text portions of this message have been removed]







[Non-text portions of this message have been removed]