CAD CAM EDM DRO - Yahoo Group Archive

Re: High voltage servo controller

Posted by vrsculptor
on 2008-06-05 16:29:40 UTC
Mina,
If you are adventurous and electronically savvy there is also the UHU
high power step direction drives (160+ volts, 25 amp) at less than
$200 each. The drives are in beta mode and only available as kits.
There are some videos posted by satisfied users on the site.

See:
<http://www.youtube.com/watch?v=OT6vobT9mAw>
<http://www.cnczone.com/forums/showthread.php?t=14217&page=999>

Roger

Discussion Thread

Mina Aboul Saad 2008-06-04 05:33:14 UTC High voltage servo controller Dan Mauch 2008-06-04 07:35:48 UTC Re: [CAD_CAM_EDM_DRO] High voltage servo controller Stephen Wille Padnos 2008-06-04 07:53:53 UTC Re: [CAD_CAM_EDM_DRO] High voltage servo controller mina_aboulsaad 2008-06-04 11:28:39 UTC Re: High voltage servo controller gcode fi (hanermo) 2008-06-04 11:39:12 UTC Re: [CAD_CAM_EDM_DRO] Re: High voltage servo controller Jim Peck 2008-06-04 17:16:10 UTC RE: [CAD_CAM_EDM_DRO] High voltage servo controller vrsculptor 2008-06-05 16:29:40 UTC Re: High voltage servo controller Jon Elson 2008-06-05 18:41:41 UTC Re: [CAD_CAM_EDM_DRO] Re: High voltage servo controller vrsculptor 2008-06-05 22:25:07 UTC Re: High voltage servo controller Henrik Olsson 2008-06-06 03:20:58 UTC Re: [CAD_CAM_EDM_DRO] Re: High voltage servo controller Jcullins 2008-06-06 06:38:28 UTC RE: [CAD_CAM_EDM_DRO] Re: High voltage servo controller Jon Elson 2008-06-06 09:05:42 UTC Re: [CAD_CAM_EDM_DRO] Re: High voltage servo controller