RE: [CAD_CAM_EDM_DRO] EMC2 requirements.

Jon,

I dont what other differences there is, but I could not instal it on the 256
Mb, so there must be other dependencies...

I could run the Live CD without installing, but when I tried to install, it
would slow down and use the CD rom extreamly much to the end where it would
just not react to human intervention, and just keep the CD-Rom running.

Put in the ram, and it worked like a treat... (-:

But I have also hear others that have installed on low memory machines.. but
I have no clue how they did it (-:

Best Regards
Kim Mortensen

-----Original Message-----
From: CAD_CAM_EDM_DRO@yahoogroups.com
[mailto:CAD_CAM_EDM_DRO@yahoogroups.com]On Behalf Of Jon Elson
Sent: 25. august 2008 18:00
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: Re: [CAD_CAM_EDM_DRO] EMC2 requirements.


Kim Mortensen wrote:

> I tried to install EMC2 on a 1.8 GHZ machine that had 256 Mb Ram (shared
> video memory), where I cut down the video part to 32Mb, but still

couldent

> install it.. When I inserted 512 Mb Extra it worked perfectly.. so I

think u

> definately need some more ram.

I have successfully installed the Ubuntu version of EMC2 with as
little as 192 MB of ram. On another system I went up to 256 MB
during the install, then dropped back to 128 MB when running
from tha hard disk. I calculate when the video is taking over
32 MB out of 256, that should leave 224 MB still available, so
it should have worked, but.....

Jon





[Non-text portions of this message have been removed]