Re: [CAD_CAM_EDM_DRO] Slightly OT broken JT in chuck
Posted by
Leslie Newell
on 2008-10-17 15:00:43 UTC
If you open the jaws of the chuck and look inside you may find a hole in
the back, giving you access to the end of the taper. If so, insert a
punch and give it a good smack with a hammer. In the past I have drilled
a hole in a Jacobs chuck to do this.
Les
ebiz_59 wrote:
the back, giving you access to the end of the taper. If so, insert a
punch and give it a good smack with a hammer. In the past I have drilled
a hole in a Jacobs chuck to do this.
Les
ebiz_59 wrote:
> Im slightly off topic, but I am hoping for help anyway. I have an
> Albrecht keyless drill chuck with a broken Jacobs taper stem and want
> suggestions for removal of the stem so I can reuse the chuck. The
> broken stem protrudes 1/8 + out the top of the chuck, so I suppose I
> could weld something to it. Or if I could get close to some liquid N,
> maybe cool the stem fast enough to loosen. Don't know anyone with an
> EDM here in Montana. Ideas?? Thanks, Chuck
>
Discussion Thread
ebiz_59
2008-10-17 14:50:27 UTC
Slightly OT broken JT in chuck
Leslie Newell
2008-10-17 15:00:43 UTC
Re: [CAD_CAM_EDM_DRO] Slightly OT broken JT in chuck
Andy Wander
2008-10-17 16:11:57 UTC
RE: [CAD_CAM_EDM_DRO] Slightly OT broken JT in chuck
Steve Blackmore
2008-10-17 16:59:52 UTC
Re: [CAD_CAM_EDM_DRO] Slightly OT broken JT in chuck
Chuck Merja
2008-10-18 02:24:24 UTC
RE: [CAD_CAM_EDM_DRO] Slightly OT broken JT in chuck