RE: [CAD_CAM_EDM_DRO] Re: Sorry
Posted by
Alan Marconett
on 2009-03-04 10:31:32 UTC
If you're thinking of a small mill like a Sherline, then there's a white
paper in the files over on the SherlineCNC list.
Alan KM6VV
paper in the files over on the SherlineCNC list.
Alan KM6VV
> -----Original Message-----
> On Behalf Of Yahoo
>
> No need to apologize unless you say something overtly antagonistic, which
> it
> doesn't seem to me you have done so far. It sounds like you are starting
> with little or no knowlwdge of CNC so, assuming that, there are some
> useful
> tutorials I can recommend on:
>
> http://www.ohmikron.com/
>
> Look at the "Instructions" section of the menu, specifically the parts
> about
> stepper motors and G-codes.
> --
> Phil Mattison
Discussion Thread
William Scalione
1999-05-25 19:31:09 UTC
Sorry
garfield@x...
1999-05-25 19:39:32 UTC
Re: Sorry
Dan Mauch
1999-05-26 05:56:26 UTC
Re: Sorry
Charles Gallo
1999-10-13 15:15:30 UTC
Sorry
a_k@a...
2001-07-24 04:24:32 UTC
Sorry
hanson_whitey
2009-03-03 23:35:34 UTC
Sorry
Andy Wander
2009-03-04 05:50:20 UTC
RE: [CAD_CAM_EDM_DRO] Sorry
whitey
2009-03-04 07:14:05 UTC
Re: [CAD_CAM_EDM_DRO] Sorry
Yahoo
2009-03-04 08:31:57 UTC
Re: Sorry
whitey
2009-03-04 08:51:54 UTC
Re: [CAD_CAM_EDM_DRO] Re: Sorry
caudlet
2009-03-04 10:00:22 UTC
Re: Sorry
gcode fi (hanermo)
2009-03-04 10:17:46 UTC
Re: [CAD_CAM_EDM_DRO] Re: Sorry
Alan Marconett
2009-03-04 10:31:32 UTC
RE: [CAD_CAM_EDM_DRO] Re: Sorry
whitey
2009-03-04 13:07:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: Sorry