Re: [CAD_CAM_EDM_DRO] Re: Synchronizing Two Servo Motors

I think you misunderstood my proposal.

Use the belt as the drive mechanisn, not an axis coupling device.

So you have a belt on either side of the gantry, running along the rail.
Maybe the belt is 6m per side, looped and joined at the carrige.

Then at one end of the machine, you have a shaft, as wide as the rails, with
a pulley at each end. The motor is directly coupled to the shaft.

And the belts are perfectly suited to this application.

Regards
Roland

2009/3/11 Yahoo <yahoo@...>

> Unfortunately those are open-ended belts. I need continuous loop, which
> tops
> out at 48", then jumps to 120" with nothing in between.
> --
> Phil Mattison
>
>
> ----- Original Message -----
> From: Franklin York <fbcsnh@... <fbcsnh%40comcast.net>>
> To: <CAD_CAM_EDM_DRO@yahoogroups.com <CAD_CAM_EDM_DRO%40yahoogroups.com>>
> Sent: Wednesday, March 11, 2009 11:17 AM
> Subject: RE: [CAD_CAM_EDM_DRO] Re: Synchronizing Two Servo Motors
>
> > Phil try this link https://sdp-si.com/eStore/Direct.asp?GroupID=214
> >
> >
> >
> > Frank
> >
>
>
>

[Non-text portions of this message have been removed]