Re: [CAD_CAM_EDM_DRO] Re:Do stepper motors get old?
Posted by
Roland Jollivet
on 2010-01-13 09:23:02 UTC
I have found, after collecting many 2nd stepper motors, that some(all
disconnected) are very free to turn, while others present a hard cogging.
But I'm not sure if they have different internal designs that make them so,
or if they're basically worn out. Like many products, the stickers offered
precious little info on the sticker, so I could'nt look them up.
Roland
2010/1/13 Neil Gillies <neil@...>
disconnected) are very free to turn, while others present a hard cogging.
But I'm not sure if they have different internal designs that make them so,
or if they're basically worn out. Like many products, the stickers offered
precious little info on the sticker, so I could'nt look them up.
Roland
2010/1/13 Neil Gillies <neil@...>
>[Non-text portions of this message have been removed]
>
> Hi Brian
>
> In my real job, I regularly have to replace steppers that are about 5 years
> or older.
> As the salesman says, the magnets get weak and the motors start to
> cavitate.
> We mostly use size 23 compumotors and run pretty much 24/7, so 10 years of
> intermittent use would be about right.
> Modern motors with rare-earth magnets __seem__ to last a wee bit longer.
>
> I'm pretty sure it's got nothing to do with your old Mac operating system
> 'though LOL :-)
>
> Best regards from sunny Scotland.
>
> Neil
>
> __________________________________________________________
>
> Neil D. Gillies Tel: +44 (0)1383-823489
> iGull.co.uk
> 11 River View neil@... <neil%40igull.co.uk>
> Dalgety Bay, Fife http://www.igull.co.uk
> Scotland KY11 9YE
>
>
>
Discussion Thread
Ron Ginger
2010-01-06 05:57:37 UTC
abin Fever Expo, Jan 15-17
jerry stout
2010-01-06 16:13:59 UTC
Re: [CAD_CAM_EDM_DRO] abin Fever Expo, Jan 15-17
Ben Eisemann
2010-01-07 06:28:12 UTC
Re: [CAD_CAM_EDM_DRO] abin Fever Expo, Jan 15-17
Bryan Mumford
2010-01-12 21:42:59 UTC
Do stepper motors get old?
Neil Gillies
2010-01-13 02:45:15 UTC
Re:Do stepper motors get old?
marvfrankel
2010-01-13 03:57:58 UTC
Re: Do stepper motors get old?
johann_ohnesorg
2010-01-13 04:05:57 UTC
Re: Do stepper motors get old?
Roland Jollivet
2010-01-13 09:23:02 UTC
Re: [CAD_CAM_EDM_DRO] Re:Do stepper motors get old?
Bryan Mumford
2010-01-13 10:01:16 UTC
[CAD_CAM_EDM_DRO] Re:Do stepper motors get old?
Bryan Mumford
2010-01-13 13:05:50 UTC
Torque vs. speed
Neil Gillies
2010-01-14 03:17:37 UTC
Re: Do stepper motors get old?
johann_ohnesorg
2010-01-14 08:21:41 UTC
Re: Torque vs. speed