CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] pulse generator

on 2010-03-20 12:26:57 UTC
Just an odd thought;

If you are familiar with programming, you could make/buy a stepper driver,
like the Linistepper, and re-write the code to control the stepping for EDM.
The step/dir inputs could become advance/retract or some other function.

It gives you ability to develop a custom app using readily available
hardware.

Regards
Roland



On 20 March 2010 19:09, toolmkr <dkmach2@...> wrote:

>
>
> Hello,
> I am setting up a stepper motor to drive a mechanism at variable
> speeds, 0-60 rpm Spec sheets for the motor and driver can be found on
> Anaheim Automation web site, the motor model is 34Y214S-LW8 and the driver
> model is MBC10641. The tech support person at Anaheim Automation advised me
> that I would need to purchase an external "pulse generator" in order to make
> the setup work as I would like. I need to be able to change the speed of the
> stepper motor on-the-fly without having it connected to a computer by simply
> turning a knob such as on a potentiometer.
> He told me I would be able to pick up a pulse generator from Radio Shack,
> however I was at the store and they were not too helpful.
> Any assistance would be appreciated.
>
> Sincerely,
> Denis
>
>
>


[Non-text portions of this message have been removed]

Discussion Thread

toolmkr 2010-03-20 10:12:46 UTC pulse generator Henrik Olsson 2010-03-20 10:39:08 UTC Re: [CAD_CAM_EDM_DRO] pulse generator Roland Jollivet 2010-03-20 12:26:57 UTC Re: [CAD_CAM_EDM_DRO] pulse generator stan 2010-03-22 10:02:43 UTC Re: [CAD_CAM_EDM_DRO] pulse generator Wade Penney 2010-03-23 02:44:53 UTC pulse generator Jamie Cunningham 2010-03-23 02:45:59 UTC Re: [CAD_CAM_EDM_DRO] pulse generator turbulatordude 2010-03-23 02:47:01 UTC Re: pulse generator johann_ohnesorg 2010-03-23 05:49:34 UTC Re: pulse generator David G. LeVine 2010-03-23 09:17:49 UTC Re: [CAD_CAM_EDM_DRO] Re: pulse generator caudlet 2010-03-24 08:28:14 UTC Re: pulse generator Don Butterworth 2010-03-24 10:03:37 UTC RE: [CAD_CAM_EDM_DRO] Re: pulse generator markotime 2010-03-25 05:39:47 UTC Re: pulse generator