Re: [CAD_CAM_EDM_DRO] Re: Servo motor questions
Posted by
Steve Blackmore
on 2010-06-13 01:38:06 UTC
On Sat, 12 Jun 2010 22:10:11 -0000, you wrote:
Over tensioning causes premature bearing failure ;)
Belt tension is measure by deflection midway between longest span.
Deflection test force (N) Newtons = force to be transmitted (N)/20
At that test force
Deflection (mm) = Drive span length/50
Good info here
http://www.hpcgears.com/technical.htm
Steve Blackmore
--
>The problem I see with a jack screw is the ability to measure tension. From what i understand timing belts have specs for tension and i think a 5M belt is 50 LBS? So i was thinking of putting a hook or something on motor to pull it with a pull scale. Well maybe if the jack screw was a finger tighten type thing it would work. Pull 50 LBS on the scale and finger tighten jack screw to hold motor in place. Other wise you would use 1 hand to hold scale, another hand to run ratchet and last hand to hold nut.Not that simple
Over tensioning causes premature bearing failure ;)
Belt tension is measure by deflection midway between longest span.
Deflection test force (N) Newtons = force to be transmitted (N)/20
At that test force
Deflection (mm) = Drive span length/50
Good info here
http://www.hpcgears.com/technical.htm
Steve Blackmore
--
Discussion Thread
cnc_4_me
2010-06-11 15:45:00 UTC
Servo motor questions
Stephen Wille Padnos
2010-06-11 17:29:02 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor questions
Michael Fagan
2010-06-11 18:11:55 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor questions
cnc_4_me
2010-06-11 19:16:16 UTC
Re: Servo motor questions
Jon Elson
2010-06-11 21:52:25 UTC
Re: [CAD_CAM_EDM_DRO] Re: Servo motor questions
Randall Wink
2010-06-12 04:33:18 UTC
RE: [CAD_CAM_EDM_DRO] Re: Servo motor questions
Dan Mauch
2010-06-12 07:02:23 UTC
RE: [CAD_CAM_EDM_DRO] Servo motor questions
cnc_4_me
2010-06-12 15:10:43 UTC
Re: Servo motor questions
Randall Wink
2010-06-12 16:09:58 UTC
RE: [CAD_CAM_EDM_DRO] Re: Servo motor questions
Nathan Clark
2010-06-12 23:49:04 UTC
Re: [CAD_CAM_EDM_DRO] Re: Servo motor questions
Steve Blackmore
2010-06-13 01:38:06 UTC
Re: [CAD_CAM_EDM_DRO] Re: Servo motor questions