CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: EMC and lathes?

on 2010-12-22 12:52:15 UTC
On Wed, 22 Dec 2010 10:35:38 -0600, you wrote:


>> Does the lathe mode support threading? If so what about multi start threads? Looking at doing some small parts where I would prefer to set up a small lathe. But it will require multi start threading.
>>
>>
>Yes, of course. There should be no problem doing multistart threads,
>but I admit I have not done them.

Tim, Jon

Multistart threads are easy. I've done them with both Mach and EMC. The
technique is, do the first thread passes completely, then start the next
thread 1/2 pitch in distance further back on the Z axis for a two start
thread, or 1/3 pitch back on a 3 start etc.

As long as you have no lost motion or moved the stock in the chuck it
works perfectly.

Steve Blackmore
--

Discussion Thread

timgoldstein 2010-12-20 10:28:50 UTC EMC and lathes? Steve Blackmore 2010-12-20 13:12:34 UTC Re: [CAD_CAM_EDM_DRO] EMC and lathes? Jon Elson 2010-12-20 18:56:49 UTC Re: [CAD_CAM_EDM_DRO] EMC and lathes? kabowers@N... 2010-12-21 05:52:07 UTC Re: [CAD_CAM_EDM_DRO] EMC and lathes? Jon Elson 2010-12-21 09:24:03 UTC Re: [CAD_CAM_EDM_DRO] EMC and lathes? kabowers@N... 2010-12-21 19:24:34 UTC Re: [CAD_CAM_EDM_DRO] EMC and lathes? Jon Elson 2010-12-21 22:15:15 UTC Re: [CAD_CAM_EDM_DRO] EMC and lathes? kabowers@N... 2010-12-22 05:49:55 UTC Re: [CAD_CAM_EDM_DRO] EMC and lathes? timgoldstein 2010-12-22 05:50:08 UTC Re: EMC and lathes? Andy Wander 2010-12-22 06:43:50 UTC RE: [CAD_CAM_EDM_DRO] Re: EMC and lathes? Ron Thompson 2010-12-22 07:36:38 UTC Re: [CAD_CAM_EDM_DRO] EMC and lathes? Jon Elson 2010-12-22 08:35:45 UTC Re: [CAD_CAM_EDM_DRO] Re: EMC and lathes? Jon Elson 2010-12-22 08:51:07 UTC Re: [CAD_CAM_EDM_DRO] EMC and lathes? kabowers@N... 2010-12-22 09:00:47 UTC Re: [CAD_CAM_EDM_DRO] EMC and lathes? Danny Miller 2010-12-22 09:29:28 UTC Re: [CAD_CAM_EDM_DRO] EMC and lathes? Steve Blackmore 2010-12-22 12:52:15 UTC Re: [CAD_CAM_EDM_DRO] Re: EMC and lathes? timgoldstein 2010-12-24 05:21:12 UTC Re: EMC and lathes?